08-27-2013 07:05 AM
I remotely connect to this and other devices connected to this router though a vpn, I can connect to the other devices on there LAN address but not the router I have to connect to the WAN address is there a setting on it that I need to change. on the old SRP527 this is not a problem, it only seams to be affecting the new model
08-30-2013 06:51 AM
Dear Peter,
Thank you for reaching the Small Business Support Community.
I am not sure I quite understand your inquiry, but if you wonder about remote access management on the SRP527 please check on the below document;
http://sbkb.cisco.com/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=2444
If this is not what you are looking for please explain and/or contact the Small Business Support Center to have a TAC engineer better assist you;
https://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html
Please do not hesitate to reach me back if there is any further assistance I may help you with.
Kind regards,
Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer
*Please rate the Post so other will know when an answer has been found.
09-06-2013 08:22 AM
thanks the remote access is all set correct on the router i started a chat and remote session with an engineer but he couldnt identify the problem so i have sent him some information on the network setup and waiting on his reply.
09-24-2013 05:51 AM
I have been away so not much has progressed with this so I was doing some browsing and came across this;
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080094634.shtml
from what I understood it sounds like something similar to me in that it wont allow connection to the router through the VPN, but I don't fully understand it as it is slighlty different to my setup.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: