I setup an ipsec vpn between two WAG54GP2 and everything works properly, since the two networks communicate properly with each other without any additional configuration.
One of the two router (172.30.209.130) routes traffic to a MPLS network (gateway 172.30.209.129) by the following static routes:
| Destination LAN IP | Subnet Mask | Gateway | Hop count | Interface |
|---|
| 62.94.58.1 | 255.255.255.255 | 0.0.0.0 | 1 | WAN (Internet) |
| 192.168.11.30 | 255.255.255.255 | 172.30.209.129 | 1 | LAN & Wireless |
| 172.30.140.130 | 255.255.255.255 | 172.30.209.129 | 1 | LAN & Wireless |
| 172.30.209.128 | 255.255.255.192 | 0.0.0.0 | 1 | LAN & Wireless |
| 192.168.9.0 | 255.255.255.0 | 172.30.209.129 | 1 | LAN & Wireless |
| 0.0.0.0 | 0.0.0.0 | 62.94.58.1 | 1 | WAN (Internet) |
From the remote router (192.170.1.1) I can not access the MPLS network as trying to configure the same route I have in response "The values you entered are invalid. Please try again."
I get the same error trying to insert as a gateway to the remote router 172.30.209.130.
How do I configure the router for remote access to the MPLS network?
