cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

450
Views
5
Helpful
2
Replies
Len Levin
Beginner

VLAN Rv160W

I have a customer that I just updated their edge router to a RV160W.  Not a big customer.  The RV160W is providing all of the functions for th business.

 

A security camera company installed cameras and a recording device.  The location has multiple buildings without connectivity between the builds.  He used Ubiquity access points to bridge the main wireless network between the buildings.

 

I want to isolate the camera system from the rest of the network.  My plan is to setup another VLAN and assign it to a specific LAN port on the RV160W.  I would also like to have the 2nd VLAN to have it's own DHCP range.  This will allow the cameras to have their own SSID.

 

I have very little experience doing this kind of set up.

 

Any suggestions of best practices would be greatly appreciated.

 

Thanks.

 

Len

2 REPLIES 2

I tried to configure a second VLAN, in my RV 160 like is shown in the article in the attached link. I have not had much success. I must say that I am at a loss. one vlan is used for service, the second vlan is used for static NAT and i just rtied to add a third vlan for RAS access. I can not ping or access a divice that is attached to the third vlan. help!