cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

367
Views
0
Helpful
2
Replies
raul.gadea1
Beginner

VPN IPSec SNAT RV320

I have a RV320 router, I created 2 VPN tunnel IPSec but remote LAN only accept 1 IP.
I need connection to remote LAN in all LAN. How I can masquerade for this IP? I do not find SNAT option.

Could I route from other VLAN?

2 REPLIES 2
mdobiac
Participant

Hello raul.gadea1,

What you will have to do is configure another VPN gateway to gateway tunnel and in the remote subnet setting put in the subnet of the other VLAN.  This will allow the pass through of the subnets over the VPN tunnel/s.

Hope this help,

 

Michael D.

If this post is helpful please rate or mark as correct.

Hi again,

Excuse me maybe not expressed well. I explain better the scenario:

I not have access to remote LAN because is it another company and i can not change this parameters in remote Router. 

I created 2 VPN tunnels gateway to gateway and connection is alive, but they only allow one IP in remote LAN and all traffic of my LAN should be masquerade in this IP.

How can i masquerade all traffic of my subnet in only one IP? 

Thanks