WRVS4400 - reserve DHCP?

[seiadmincisco]

i am looking at upgrading to this router

i would like to reserve some DHCP addresses, but i looked through the manual & didn't see it mentioned, but i did see it mentioned in 1 of the firmware upgrades

is it available?

mark

[Te-Kai Liu]

Mark, all RV series routers, including WRVS4400N, support this feature.

[seiadmincisco]

thanks for the quick answer

not sure if you can answer this one - i see the WRVS4400n and V2 for sale, is there a difference other than the VPN supported?

mark

[Te-Kai Liu]

WRVS4400N v1.1 and WRVS4400N v2 have the same features, although the underlined WiFi chips used are different.

The only practical difference is that the former was manufactured in earlier days.

[seiadmincisco]

i have the router now

can you please explain how to do it

i see how to enter fixed IP's, but i don't see how to reserve a DHCP address

i want the same MAC address to get the same IP from DHCP each time

mark

[Te-Kai Liu]

Does the router has the latest firmware? The Reserved DHCP feature is usually available as part of the DHCP Server configuration.

[seiadmincisco]

yes, just installed 2.0.2.1

mark

[Te-Kai Liu]

Please checkout the following page on the Web GUI.

Setup>LAN>Static IP Mapping

[seiadmincisco]

i used this to define a static address outside the normal DHCP range

i can define an address within the DHCP range?

mark

[Te-Kai Liu · Accepted solution]

Yes, you can.