I've trying to upgrade the Firmware of WRVS4400N from 2.0.0.9 to the newest 2.0.1.3. Backup setting, upload the new firmware in the webinterface. Everything ok. Then I wait almost an hour, but the router did not reboot and reconnect to the webinterface. Instead, the router blinking on "Power" an "Diag". So i try to reset the router at the reset button backsides. But nothing happens, also these lamps blinking. Also I cannot connect to the webinterface. What's going on here? How can I solve this problem?
Regards Göran
