cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
529
Views
0
Helpful
1
Replies
Beginner

Change 800 Series run-config from entry router to bridge?

Please describe what is necessary for me to convert the running-config of my Dino 871W from the entry router to a bridge router? The current running-config was used when the router was directly connected to a Cable Modem.

 

Now, I'm using the Cable Co.s Wifi Router, but I'd like to cascade one of the ethernet ports to the 871W for wired connection to a few new sandbox servers. I need these servers to serve the LAN only (not the WWW).

 

The layout is,

    WWW  -->

        Cable Modem  -->

            Router 1 (DLink from Comcast) wireless and ethernet  -->

                Router 2 (Cisco 871W) ethernet traffic.

 

From what I gather, I need to

    - set the addresses to the same subnet (192.168.1.255)

    - modify the 871 running-config (maybe the FastEthenet4 section?) to 'bridge'

    - Port forward from DLink to 871

 

How am I doing?

Everyone's tags (3)
1 REPLY 1
Cisco Employee

Re: Change 800 Series run-config from entry router to bridge?

Hello,

My name is Rozana and I am an engineer from the SBSC team,

The 871 router is covered by the Enterprise team.
Please, open the thread in their section, so they can answer your question.