cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

855
Views
0
Helpful
1
Replies
tdorschner
Beginner

SA520 blocks internal sites with ProtectLink

Hi - I have 3 Cisco SA520's.  I have one main office and 2 branch offices and the devices are programmed to have VPN point-to-point.  I have installed 1.1.65 firmware on each device.  I recently purchased and started playing with ProtectLink to keep my staff from using unapproved websites. 

Once I turn on URL Filtering:

"Enable URL Filtering"

Filtering : "Social during Business and Leisure Hours"

Business Days: M-F

The filtering of social sites works correctly.  EXCEPT - I have cameras at the branch offices that I could connect to before (It's just a URL http://10.10.2.40 or http://10.10.3.40 in a browser).  Once I enable this, I can no longer connect to them.  In an attempt to bypass the URL Filtering, I added the IP addresses of both cameras to the Approved URLs page and also enabled the Approved URLs List.  When this did not work, I also tried adding the IP addresses to the Approved Clients list and this also was not my solution.

I'm scratching my brain at this one so any help would be greatly appreciated!

1 REPLY 1
weilia
Cisco Employee

Hi,

Please upgrade your software to the latest 2.1.18. We have a few Protectlink related

issues fixed in the latest release.

regards,

wei