cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

609
Views
0
Helpful
3
Replies
luisbubu90
Beginner

sa520<---s2s---->rv110

Hi folks, I am trying to create a VPN, I hava a sa520 and rv110, I can´t reach any network neither from sa520 to rv110, nor vice versa, it is posible to create this vpn among these devices?

Thanks

2 ACCEPTED SOLUTIONS

Accepted Solutions
Tom Watts
Advisor

Hi Luis, yes. The RV110 did not natively support a site to site VPN tunnel so make sure to be on the latest firmware. You may also want to verify your SA520 is using the 2.2.0.7 or the 2.1.7.1. If your SA has 2.1.72, you may want to get out of that software as it is not supported.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

View solution in original post

jonatrod
Rising star

Good morning

Thanks for using our forum

Hi Luis, my name is Johnnatan and I am part of the Small business Support community.

To add to Tom´s post, you check these document in order to configure them.

SA520 (page 137)

http://www.cisco.com/en/US/docs/security/multi_function_security/multi_function_security_appliance/sa_500/admi

RV110 (page 100)

http://www.cisco.com/en/US/docs/routers/csbr/rv110w/administration/guide/rv110w_admin.pdf

I hope you find this answer useful, if it was satisfactory  for you, please mark the question as Answered. Please rate post you consider useful.

Happy holidays !!!!

Johnnatan Rodriguez Miranda.

Cisco network support engineer

“Please rate useful posts so other users can benefit from it” Greetings, Johnnatan Rodriguez Miranda. Cisco Network Support Engineer.

View solution in original post

3 REPLIES 3
Tom Watts
Advisor

Hi Luis, yes. The RV110 did not natively support a site to site VPN tunnel so make sure to be on the latest firmware. You may also want to verify your SA520 is using the 2.2.0.7 or the 2.1.7.1. If your SA has 2.1.72, you may want to get out of that software as it is not supported.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

View solution in original post

jonatrod
Rising star

Good morning

Thanks for using our forum

Hi Luis, my name is Johnnatan and I am part of the Small business Support community.

To add to Tom´s post, you check these document in order to configure them.

SA520 (page 137)

http://www.cisco.com/en/US/docs/security/multi_function_security/multi_function_security_appliance/sa_500/admi

RV110 (page 100)

http://www.cisco.com/en/US/docs/routers/csbr/rv110w/administration/guide/rv110w_admin.pdf

I hope you find this answer useful, if it was satisfactory  for you, please mark the question as Answered. Please rate post you consider useful.

Happy holidays !!!!

Johnnatan Rodriguez Miranda.

Cisco network support engineer

“Please rate useful posts so other users can benefit from it” Greetings, Johnnatan Rodriguez Miranda. Cisco Network Support Engineer.

View solution in original post

I´ll configure them and check the firmware version.

Thanks for youe help