cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.
Get the latest news in this issue of the Cisco Small Business Monthly Newsletter

833
Views
0
Helpful
1
Replies
Highlighted
Beginner

SA520W not getting full bandwidth on 35x5 cable connection

We just upgraded our cable connection from 10x1 (10Mbps up / 1Mbps down) to 35x5 and we are not getting the full bandwidth from our SA520W; At 10x1 we were getting every bit of it.  Once we switched we only seem to be getting about 15x3.5.  I reconfigured the unit to accommodate the new IP and gateway, etc. and then tested the speed, 15x3.5.  I rebooted the SA520W and we got the full 35x5 for a short while then it reverted back to 15x3.5.  I tried hooking a computer directly to the cable modem and I get the full bandwidth.

As far as I can tell there are no settings currently throttling the bandwidth in any way.  What am I missing?

Everyone's tags (3)
1 REPLY 1
Highlighted
Beginner

SA520W not getting full bandwidth on 35x5 cable connection

Nevermind.  I found another post suggesting that IPS might be casuing the problem.  Once I disabled that we're getting the full 35x5!  IPS hasn't been updated in a year anyway and I'm not sure it ever really DID anything anyway.  :/