cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.
Get the latest news in this issue of the Cisco Small Business Monthly Newsletter

521
Views
5
Helpful
6
Replies
Highlighted
Beginner

L2 and L3 in SG350-10P

HI All,

I would like to ask you where I can find the option to change my SG350-10P form L2 to L3 layer?

In SG300 switch it is in Administration/System Settings but if I wanna find it in my SG350-10P it is not there. Just to add I changed in my SG350 switch 'Display mode' form 'Basic' to 'Advanced'. Attached my screen.

Waiting for the feedback.

Thanks

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Advisor

Re: L2 and L3 in SG350-10P

Hi @Lukasz1977 

 

Try this:

029DA047-DFDF-4F71-A71D-03C89B5B7D74.jpeg

Regards

View solution in original post

6 REPLIES 6
Highlighted
VIP Advisor

Re: L2 and L3 in SG350-10P

Hi @Lukasz1977 

 

Try this:

029DA047-DFDF-4F71-A71D-03C89B5B7D74.jpeg

Regards

View solution in original post

Highlighted
Beginner

Re: L2 and L3 in SG350-10P

Thanks,

Will do.

Highlighted
Beginner

Re: L2 and L3 in SG350-10P

Please give an answer why Tagged pots do not work in this switch. Even I want try to set it I can but after I save it I can not see Tagged working. Only Unttaged/Excluded

Highlighted
VIP Mentor

Re: L2 and L3 in SG350-10P

There is no Configuration required for 350/5XX series like 300,

they work both L2/L3 mode you need to just configure, check below video help you :

 

https://www.youtube.com/watch?v=NLMKwYSlQDY

BB
*** Rate All Helpful Responses ***
Simply put, Layer 3 switches are super-fast routers that do Layer 3 forwarding in hardware, such as switches. Learn about Layer 3 Switching on SG350 and SG55...
Highlighted
Beginner

Re: L2 and L3 in SG350-10P

Thanks,

Will try to use it.

 

Highlighted
Beginner

Re: L2 and L3 in SG350-10P

Please give an answer why Tagged pots do not work in this switch. Even I want to set it I can but after I save it I can not see Tagged ports working. Only Unttaged/Excluded is visiable.