I would like to ask you where I can find the option to change my SG350-10P form L2 to L3 layer?
In SG300 switch it is in Administration/System Settings but if I wanna find it in my SG350-10P it is not there. Just to add I changed in my SG350 switch 'Display mode' form 'Basic' to 'Advanced'. Attached my screen.
Waiting for the feedback.
Solved! Go to Solution.
Please give an answer why Tagged pots do not work in this switch. Even I want try to set it I can but after I save it I can not see Tagged working. Only Unttaged/Excluded
There is no Configuration required for 350/5XX series like 300,
they work both L2/L3 mode you need to just configure, check below video help you :
Please give an answer why Tagged pots do not work in this switch. Even I want to set it I can but after I save it I can not see Tagged ports working. Only Unttaged/Excluded is visiable.