L2 and L3 in SG350-10P

[Lukasz1977]

HI All,

I would like to ask you where I can find the option to change my SG350-10P form L2 to L3 layer?

In SG300 switch it is in Administration/System Settings but if I wanna find it in my SG350-10P it is not there. Just to add I changed in my SG350 switch 'Display mode' form 'Basic' to 'Advanced'. Attached my screen.

Waiting for the feedback.

Thanks

[luis_cordova · Accepted solution]

Hi @Lukasz1977 

Try this:

Regards

[Lukasz1977]

Thanks,

Will do.

[Lukasz1977]

Please give an answer why Tagged pots do not work in this switch. Even I want try to set it I can but after I save it I can not see Tagged working. Only Unttaged/Excluded

[balaji.bandi]

There is no Configuration required for 350/5XX series like 300,

they work both L2/L3 mode you need to just configure, check below video help you :

https://www.youtube.com/watch?v=NLMKwYSlQDY

[Lukasz1977]

Thanks,

Will try to use it.

[Lukasz1977]

Please give an answer why Tagged pots do not work in this switch. Even I want to set it I can but after I save it I can not see Tagged ports working. Only Unttaged/Excluded is visiable.