The increased demand for SIP trunking has caused the need to validate the interoperability of Cisco’s Unified Communications products to service providers’ SIP networks. Cisco maintains a list on the support community of all known validated SIP trunk ITSPs for BE3000.
How can additional Service Providers be added to the list? Easy, Service Provider or an accredited partner must follow the process described here (Registered partners only). Process is summarized in following steps:
The process is:
Service Provider express interest on certifying BE 3000 SIP trunk and be listed. For this we recommend Service Providers contact your Cisco Account Manager, or send an email to firstname.lastname@example.org.
Service Provider Engineer Installs Advanced Connection pack.
Service Provider performs Self-testing according to the provided BE3000 sample SP SIP Master Test plan (note we assume you have already a BE 3000 unit, if not the case, your Cisco Account Manager may be able to source you one).
After tests are completed, SP sends the test plan results, the test sniffer traces, a screen capture of BE3000 SIP trunk Configuration and CLI configuration of CUBE.
With this information, Cisco completes the SIP trunk configuration document and posts it on the support community.
Hi, I just bought the above switch to power my network and it works just fine till I want to power any POE device. I tried different devices and non will get power from the switch.The strange thing is, that I can't even open the POE configuration in ...
Greetings, I am having some issue for vloce config for my new SG220-26P-K9 For voice vlan, I had configured ports as access port under data vlan with Voice mode in auto. But the IP phone were not getting ip address from voice vlan instead w...
Hi Support Team, We have recently purchased SPA501G and have to enable LLDP-MED configs and enable Web Interface for config page.I am not able to find out the IVR code for LLDP-MED enabling.And also, I am looking for how to enable Web Interface link(...
Hi everyone,This is my first time configuring WAP581, I need your help!Both ports are connected to the POE switch, but only a 169.254.163.211 address is displayed through the packet capture, and FINDIT has not been able to find any device. The device has ...
Hello,while I am waiting for my first 4 switches I would like to start practicing, simulating my connections, various configurations, vlan, etc, I can do it, I downloaded "Cisco Packet Tracer" but I can't find my switches. There are other tools that refer...