The increased demand for SIP trunking has caused the need to validate the interoperability of Cisco’s Unified Communications products to service providers’ SIP networks. Cisco maintains a list on the support community of all known validated SIP trunk ITSPs for BE3000.
How can additional Service Providers be added to the list? Easy, Service Provider or an accredited partner must follow the process described here (Registered partners only). Process is summarized in following steps:
The process is:
Service Provider express interest on certifying BE 3000 SIP trunk and be listed. For this we recommend Service Providers contact your Cisco Account Manager, or send an email to email@example.com.
Service Provider Engineer Installs Advanced Connection pack.
Service Provider performs Self-testing according to the provided BE3000 sample SP SIP Master Test plan (note we assume you have already a BE 3000 unit, if not the case, your Cisco Account Manager may be able to source you one).
After tests are completed, SP sends the test plan results, the test sniffer traces, a screen capture of BE3000 SIP trunk Configuration and CLI configuration of CUBE.
With this information, Cisco completes the SIP trunk configuration document and posts it on the support community.
Hi,POESWKLEESF01#sh bootvarImage Filename Version Date Status----- --------- --------- --------------------- -----------1 image-1 220.127.116.11 26-Sep-2019 20:04:47 Not active2 image-2 18.104.22.168 02-Dec-2019 00:24:43 Active*"*" designates that the image was sele...
Hello, I have a RV345 small business router. I use the Shields Up service from GRC.com to test my router against incoming ports. This service scans ports 0 thru 1055. Under normal circumstances, all ports should show stealth as I do...
Hi guys, Quick question. A friend bought a used SPA112 on eBay, but he can't connect to it through the web interface or the IVR interface.I believe the web interface has been blocked though the UI (Screenshot taken from another SPA112):Then, if tryin...
Hello Everyone, I'm looking at getting the C1116-4P for a branch office. This office will have a layer 2 point to point connection provided by the ISP back to the HQ. One of the ideas being entertained as well is ...
Hello, I'm in trouble with a SG350X stack of 4 SG350X switches. For a unknown reason, the admin password has changed and I'm trying to recover access to the switches.So I followed the various articles from Cisco, but the switch newer goes in "passwor...