The Cisco WebEx Telepresence bridge service enables WebEx Telepresence users to do the following:
Conference up to six (for 6-port) or 12 (for 12-port) video and/or audio parties together. For example, a 6-port conference could include a combination of four video participants and two audio participants. Once the bridge is full, new users trying to access the bridge hear an audio prompt indicating the bridge is full. New parties cannot join the bridge until a port becomes available.
Accept video calls from WebEx Telepresence users as well as compatible H.323/SIP-based video devices.
Accept audio-only calls from any PSTN landline or mobile phone.
Share data presentations with other WebEx Telepresence devices (including Cisco Jabber Video) as well as SIP/H.323 devices.
Data sharing among WebEx Telepresence devices uses the IETF standard known as the Binary Floor Control Protocol (BFCP) or RFC4582. Non-WebEx Telepresence, SIP-based devices use BFCP, while H.323 devices use the ITU standard H.239.
The WebEx Telepresence bridge service supports up to 720p30 resolution and up to 2Mbps bandwidth per participant.
The actual resolution and bandwidth are limited by your device capability, the type of WebEx Telepresence subscription, and your own bandwidth from the device to the WebEx Telepresence data centers.
I have a Cisco SG350 that I need to create 2 VLANs. VLAN1 (126.96.36.199/24) is for a Crestron Control Subnet that has a Crestron processor, Matrix and other devices on it along with an outboard router and DHCP server connected. VLAN2 (188.8.131.52...
Hello community, Hoping someone can assist with my issues. I keep getting ARP Table Overflow messages and devices on the network dropping off. I am currently running (2) Cisco SG350X-24P switches in a stack in Layer 3 mode. I have approximately 1600 ...
Hello, I have two SG350X-24 switches I want to stack. I don't have any SFP cables right now. Can I use two RJ45 Cat6a cables instead? Has anyone used 10gtek 10G SFP+ DAC Cable for Cisco SFP-H10GB-CU0.5M? I saw these on Amazon...
I regularly backup the configurations of the SF300 and SG300 switches that we have using http.This one is balking at doing that with the following message:The device is in production and I'd rather not have to go on site and fiddle with a serial port.Pres...
Hi Folks, I'd love a little help getting FindIT launched on my Win10 64 machine. I get the OS Credentials prompt as expected -- but can't seem to progress past that. If I provide my username preceded by my local machine domain, aut...