The Cisco CCA team announces the availability of the latest release of Cisco® Configuration Assistant. CCA Version 3.2.2 is a maintenance release focused on quality improvements along with a few features. Cisco Configuration Assistant is an easy-to-use interface for managing platforms within the Cisco Smart Business Communications System (SBCS) and Cisco UC 500 Systems.
This announcement covers the following topics: 1. Key Features and Enhancements
2. Key Bug Fixes
1. Key Features and Enhancements
Support for the following phones
o SPA 512/514 Gigabit Ethernet phones.
2. Key Bug Fixes:
CSCtw58664 - SSL VPN for SCCP causes crash while clearing WebVpn session
CSCtt19900 - Packet decryption fails at crypto HW engine for SSL VPN traffic with dtls
CSCtx59445 - MWI unsolicited mode fails with line key monitoring a floating extension
CSCtr07804 - UC560 CUE database corruption or crash due to high disk space usage
CSCtz08776 - CUE reports all channel resources used, not allowing calls
CSCts64962 - CUE IMAP - saved message count is negative. MWI always on
For detailed list of fixes and known caveats see Release Notes.
Please follow regular CCA documentation for this release. Release Notes are attached below.
Hi, I've already configured voice vlan on IOS switchs but I want to test configuration on SMB products.On IOS, we have to do this :SW0(config)#interface fastethernet 0/1
SW0(config-if)#switchport mode access
SW0(config-if)#switchport access vlan 10...
I installed Small Business equipment (RV340, SG350, 140ACs) before installing the Cisco Business Dashboard (CBD). When I fired up CBD: It discovered my equipment, requested existing equipment credentials, and required minor SNMP adjustments. My CBD is awa...
I am trying to set up a VLAN. I follow the documentation to the letter and i can get the VLAn 192-168.2.1 up however I cannot then log into the router. How do I set this up so the VLAN I want to create has internet access and I can still log i...
Hi there,Hi all, I have an RV345 connected to a GPON Fiber Modem.They are in PPOE mode. The internet works just fine. The modem’s config page can be accessed by going to the LAN IP address if the modem is directly connected to the PC via Etherne...