Hello I purchased the SG250 for a small classroom. I just need it to act as a simple switch when connected to my 4510. I disable Spanning tree and most of the setting, whenever I try to uplink to my 4510 the port errors out.
Hello,I have a simple working IPv6 configuration with stateless autoconfig on Dialer1 and it is working fine. My config is this:!
ipv6 dhcp pool BVI1_DHCP
I'm wondering if anyone knows if the Vodafone K5161 or HUAWEI Balong B711 4G dongles will work in either the RV130 or RV320 routers? There are some Vodafone/Huawei dongles listed in the support documents but not those particular models.Thanks
My RV340 from February 2019 has suddenly decided to only run 100mbit on the wan1 port. Happens no matter which of my internet connections from 2 diffrent providers I connect to wan1. Both connections can run 1gbit without any problem on wan2.For wan1 syst...
Hi,I am trying to assign Static ip for Any connect VPN client, Has anyone done this setup before. I can see this option on LAN/VLAN but not sure if i put MAC address for AnyConnect Client, it will assign the static IP from the AnyConnect VPN Po...