The first time you open Cisco Jabber Video for TelePresence, you can test your computer’s microphone, speakers, and camera to ensure the best video calling experience.
Do any of the following:
To test the microphone: Select the microphone you want to test. Begin talking normally. Adjust the microphone volume slider as needed so that the indicator falls in the recommended range.
To test the speakers: Select the speakers you want to test. Make sure the speakers are not muted, and click Test. Adjust the speaker volume slider as needed.
To adjust the camera: Select the camera you want to adjust. Adjust the camera as needed until the onscreen picture displays how you want to appear to other callers.
The screen that appears displays information about your maximum camera resolution, system resources, outgoing bandwidth, and expected outgoing video quality. Review the information, and then click Finish.
Hello Community, I have installed a CISCO ATA191 and trying to connect it with the German Telekom Cloud PBX Environment.Device is not getting sucessfully registered. Please find below the last entries from the LogFile.Any Explanation about the meanin...
I was setup SSL VPN. on my RV340 Mandatory Gateway SettingsGateway Interface: WAN1Gateway Port: 8443Certificate File: DefaulClient Address Pool: 10.11.12.0Client Netmask: 255.255.255.0 My LAN/DHCP Settings IP Version 4DHCP Mode: server...
I am trying to setup a site to site vpn to 2 remote sites where the remote sites have MIFI. if I use the RV160w at the remote sites, is there an issue to leverage the address from the wireless MIFI to bind the tunnel to back to the RV160 in the main...
Hi all. This is my first time setting up a home lab and I feel like the current typology I have is extremely inefficient. I have posted my current typology below and will offer a brief explanation of what I have done. Essentially what I have done is I use...
Yesterday I ended up checking for new RV340 firmware and discovered the CIsco Security Advisory on the Authenticated Remote Code Execution Vulnerabilities. I downloaded and installed the new firmware, version 1.0.03.21. However, with both p...