This document is the main reference for resellers and parterns that deploy the SPA9000 Voice System.
It includes product information for installation and Configuration using the SPA9000 Setup Wizard 2.1.
Information included in the document includes:
- Introduction to SPA9000 Voice System Products
- Deployment scenarios
- Preparation for installation
- Connecting the equipment
- Configuring the system: switch, SPA9000, SPA400, Voicemail, VoIP services, Call Routing, NAT traversal, Localization, Autoattendant, Extensions, Phones,
- Testing the system
- Maintaining your SPA9000 Voice System
- Installation workbook
SG200-50 fw: 126.96.36.199 I am currently monitoring the interface utilization of a certain server down to client PC.The network connection looks like this.Server ----- Server Sw ---- Core Sw ---- Distri Switch ---- Access Sw -- Client PC Issue:The Tx...
Hello, I have 5 VLANs in a switch SF300 configured in Layer3. I Set the switch to general mode so I could connect all the vlans. After 2 weeks that connection has been lost. Now you can only communicate with your respective gateway. Th...
RV260 Port Forwarding overrides Access Rules I’ve an RV260W with firmware 1.0.00.17 and trying to set up secure incoming port forwarding rules. I want a specific public IP address to have access to an internal service, everything else should be...
Dear Team, I have CUCM 11.5 version and my office requested me to add Corona Advisory which you might have seen it already from your belonging GSM service provider are currently doing it. When I call someone, until Party B pick up the call, i want to...