cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

Configure Time and Date Format on a Cisco IP Phone 8800 Multiplatform Series

173
Views
0
Helpful
0
Comments

Objective

This article aims to show you how to configure the time and date format on your Cisco IP Phone 8800 Series.

Applicable Devices

  • IP Phone 8800 Series

Software Version

  • 11.0.1

Configure Time and Date Format

Step 1. On your IP Phone, press the Applications button.

Step 2. Using the Navigation cluster  button, navigate to Device administration and press the Select softkey.

Step 3. Navigate to Date/Time and press the Select softkey.

Step 4. Navigate to Time format and press the right arrow on the Navigation cluster  button to select either the 12hr or 24hr format.

  • 12hr — Sets the time to a 12-hour format starting from 12:00 midnight until 11:59 AM and 12:00 PM until 11:59 PM.
  • 24hr — Sets the time to a 24-hour format starting from 00:00 (12 midnight) until 23:59 (11:59 PM).

Note: In this example, the 12hr format is chosen.

Step 5. Press the Navigation cluster  down button to navigate to Date format.

Step 6. Press the Navigation cluster  right button to select either the day/month or month/day format and then press the Set softkey.

  • day/month — Sets the day of the month to come first before the month.
  • month/day — Sets the month to come first before the day of the month.

Note: In this example, the month/day format is chosen.

Step 7. Press the Back  button to go back to the Standby mode. The date and time should now appear on the proper format that you have set.

You should now have successfully configured the time and date format on your Cisco IP Phone 8800 Series.