cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.

Configuring Ring Tones for Inbound Calls

3001
Views
0
Helpful
0
Comments

Specific ring tones can be configured in one of two ways:

1.       Directly on the phone:

a.       Dir/Directory soft key

b.      New Entry

c.       Insert Name, Number, and Select Ring, Default, by default

2.       Using the phone’s web-ui:

a.       http://<IP_of_phone>/pdir.htm

Example: For an entry that will display the following on the phone and cause the Classic-4 ring tone to play when the 2145551212 phone calls:

Sally

2145551212

Insert the following next to the first vacant Personal Directory number: Syntax is:

n=Sally;p=2145551212;r=4

Where:

n—name for listing

p=incoming phone number that will cause the special ring

r—identifies the ring tone as listed http://<IP_of_phone>/admin/advanced > Ring Tone > RingN:

Note that:

“0” in this syntax enables a silent ring. The phone’s LEDs will flash, but the phone will not ring
Ring4: n=Classic-4;w=3;c=4 is called “4” in this syntax

Ring9: n=Simple-5;w=2;c=5 is called “9” in this syntax

Ring10: n=Office;w=4;c=1 is called “10” in this syntax

<end>

CreatePlease to create content
Webcast-ISE Deployment and Best Practices