Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
Debug and syslog Messages from the SPA3xx, SPA5xxG, SPA9xx, & WIP310 IP Phones
In order to capture debug and syslog messages from your SPA3xx, SPA5xxG, SPA9xx, and WIP310 IP phones you need to enable debug and or syslog and either have a syslog server on your network or Wireshark running. [Wireshark will display debug/syslog messages with the "syslog" output filter].
Turn on debugging and or syslog messaging on your phone as follows
[You don't need both debug and syslog, debug is sufficient if you are capturing data for support]:
Determine the IP address of your syslog server c:\ ipconfig /all [Windows] $ ifconfig -a [UNIX] For this example, assume a syslog server IP address of 192.168.0.200
Configure your phone by directing your browser to: http://<IP_address_of_Phone>/admin/advanced [WIP310: http://<IP_address_of_WIP310>/admin/ ] Example: http://192.168.0.100/admin/advanced if the phone's IP address is 192.168.0.100
Enable Debug Messages by editing the following fields: i. Phone's web-ui > System tab > Optional Network Configuration > Debug Server: <IP address of syslog server> Example: 192.168.0.200 [if you are capturing with Wireshark, you do not need to use a valid syslog server's IP address, any "fake" address can be used, example 10.0.0.1] ii. Phone's web-ui > System tab > Optional Network Configuration > Debug Level: 3 iii. Phone's web-ui > Ext N > SIP Settings > SIP Debug Option: full
Enable Syslog Messages by editing the following: [step 3b is not needed if you have enabled Debug] Phone's web-ui > System tab > Optional Network Configuration > Syslog Server: <IP address of syslog server> Example: 192.168.0.200
Scroll down and click Submit All Changes
The Phone will reboot and send all debug / syslog messages to the specified IP address of the syslog server.
[Don't forget to make sure that your syslog server is running and that its IP address is what you configured on the phone.]
I made a firmeware upgrade of my WAP150 from 126.96.36.199 to 188.8.131.52. The webiterface showed the succesful upgrade and was rebooting the device. After that, the green led was blinking for hours and AP was not available on the network. After power off and...
Hello,I am hoping someone can help point me in the right direction here, I am looking for quite a basic setup. We have just purchased 6 x SG-350 and I am having trouble working out if my config is right. I am used to Catalyst IOS and these switches h...
dear all,I did a factory-reset all on my cisco catalyst 9200 switch.loaded the ios from TFTP. ( went successful )but now I want to store the ios in the flash, because when I restart the switch is goes back in the rommon mode instead of loading the ios.I h...
Hello, I need some hellp with firmware upgradeing.I have set the TFTP server, the AP in configured to fit the enviroment.When I "log" in to CLI I get "<Cisco Controller>" And the usual "enable" function does not work. Please hellp me ...
dear all,I have done a factory reset on my cisco catalyst 9200L-24P with the command: factory-reset allNow I want to load a ios from a usb stick, but it is not loading. the switch is not reading the usb stick and is stuck at the rommon mode.Copying t...