Default Configuration settings on the ESW 500 Series
The ESW 500 series switches ship with a default configuration that enables simplified installation and plug and play when connected into a Cisco Small Business network such as SBCS. The default settings are as follows:
Management VLAN is VLAN 1
Management IP Address is obtained via DHCP by default. If the switch times out on a Dynamic Host Configuration Protocol (DHCP) response, it falls back to a static IP address 192.168.10.2 with subnet mask of 255.255.255.0.
Voice VLAN is VLAN 100
Cisco Discovery Protocol (CDP) is enabled on all ports
I'm a hobbyist. I use my Cisco 525G2 with a small private Asterisk server.I'm trying to configure a Plantronics CS-540 with APC-45 cable to work with my phone.I have enabled Electronic HookSwitch in the settings on the phone.I can't get the headset to wor...
Hello. I need some help with configuring my Cisco router. I am hosting a web server in my network and I am using IPSec for some remote stuff. The problem is, my WAN is tagged (VLAN ID: 5) and the router (2.1) does not want to route traffic to my server fo...
Hi we recently purchased the CBS250 switch. From what I understand it has a web GUI and a CLI. I used a console cable to configure the switch through CLI. I put a basic config in like so: vlan 5name Voiceint vlan 5ip address 192.168...
We are holding a joint WebEx event with another company. We wondered whether it was possible to create two registration links for the same event, so that each company can track how many attendees registered through separate marketing campaigns?