cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

Dynamic Hunt Groups

3857
Views
0
Helpful
0
Comments

Configuring Dynamic Hunt Groups

Create hunt groups that allow dynamic login and logout. In the hunt group below the '*' denotes a wildcard slot for a single hunt group login. Up to 20 wildcard slots are allowed on the UC500.

config t

ephone-hunt 1 peer

pilot 255

list 201, *, *

final 298

no-reg pilot

statistics collect

ephone-hunt 1 peer

pilot 255

list 201, *, *

final 298

no-reg pilot

statistics collect


Add the ability for an ephone-dn to login or logout. In the ephone-dn of any extension you would like to have the ability to login or out of huntgroups needs the 'ephone-hunt login' command.

     ephone-dn  3  dual-line

      number 203 no-reg primary

      label 203

      description ccc Smith

      name ccc Smith

      call-forward busy 299

      call-forward noan 299 timeout 10

      corlist incoming user-domestic

      translation-profile incoming CallBlocking

      ephone-hunt login


Enable the feature access code(FAC) to allow the extension to dial the login and logout codes for the hunt group(s). There are two ways to add the access codes using fac standard or fac custom.

config t

telephony-service

fac standard

config t

telephony-service

fac custom ephone-hunt join *3

fac custom ephone-hunt cancel #3

end

Dynamic login to a hunt group when one hunt group is configured.

dial FAC code '*3'

     *3  login

     #3  logout

Dynamic login to a hunt group when multiple hunt groups are configured.

dial FAC code '*3 + hunt group pilot number'

     *3255#  login

     #3255#  logout