Enabling call waiting on the Cisco IP Phone 8800 Series Multiplatform Phone allows incoming calls to get through even if your phone is busy. If this feature is enabled, the caller will still be able to hear the other end of the line ring and allows them to wait for the call to be answered instead of hearing a busy tone.
During an active call, a waiting call will be indicated by a single beep and the session button will be flashing red.
This article aims to show you how to enable call waiting on the Cisco IP Phone 8800 Series Multiplatform through its web-based utility and phone GUI.
Enable Call Waiting
Through the Web-based Utility
Step 1. Log in to the web-based utility of the IP phone and click Admin Login > advanced.
Step 2. Click Voice > User.
Step 3. Under Supplementary Services, click on the drop-down menu for CW Setting and choose Yes.
Step 4. Click Submit All Changes.
You should now have enabled Call Waiting on your phone through the web-based utility.
Through the Phone GUI
Step 1. Press the Applications button on the IP Phone.
Step 2. Using the Navigation cluster button, navigate to User preferences then press the Select softkey.
Step 3. Choose Call preferences then press the Select softkey.
Step 4. Navigate to Call waiting and then press the Navigation cluster right button to set it to On.
Step 5. Press the Set softkey.
You should now have enabled Call waiting on your phone through the GUI.
Hello, I would like to ask few questions regarding VPN licensing. We have pbx and 80 home based agents. Do we need to purchase 1 anyconnect server license for pbx and 80 anyconnect client license? or we need to purchase 80 anyconnect server licenses and 8...
installed FindIT Network Manager 2.1.1, But i can't access the web ui using cisco username and password,even if i reset it from cli using finditmgr recoverpassword i still can't access the web ui using cisco as user and password. please help.
is there any way or any command in vtp client mode to disable feature to change VTP mode from client to any other mode for example in client mode anyone change mode to server or transparent but any restriction so nobody can change
Purchased and installed a Cisco SX350X-12-K9. When attempting to connect to the webUI, the default credentials of cisco/cisco return an "Invalid user name or password" error. After resetting the switch to default settings (by holding the reset...
I have run into something odd and cannot seem to clear the error. This is a sg350x-24p unit with latest firmware. The LED status for PoE is showing up on incorrect ports. This is also true in the web interface. Under PoE settings, the ports show incorrect...