Enabling Motion Detection on the PVC300 is a little different than the xVC2300 and WVC210 camera models.
There is a little gotcha as well WRT Percentage and Sensitivity bars in the Motion Detection window that has impacted a few people, so I decided to document how to get it working here in this document.
In this case, I am enabling Motion Detection to an NSS2050. All the steps to make this easier for you are included.
New SG200-26FP is failing to recognize Avaya 9641G VOIP Phones on some ports. Configured all ports as access ports to data VLAN. Auto Voice VLAN is enabled and working on some ports. Unknown/Disabled port diagnostics show that it failed due to trunk,...
Hi there. I've got a couple 525G2s - and trying to pair different headsets via bluetooth. After trying to pair, and not having my headsets detected, the handset then fails to work - no audio at all. Even after a factory reset.
I have been trying for 3 days to get any of the VPN client to site options on our RV340 to work. I have tried SSL VPN, L2TP, Client to Site... I have followed the directions provided by Cisco but there is no response at all when I try to conne...
Hi, SG350-20 "System Summary" unresponsive with firmware release 220.127.116.11 ( just "processing data" ). I have tried after factory reset also , but the result is the same.I had switch back to 18.104.22.168. Any suggestions ?BR, VB