StoneFax from Stonevoice (www.stonevoice.com) is a complete software solution including
a robust fax server based on T.38 able to interoperate with Cisco Unified Communications.
StoneFax delivers a complete IP fax server solution, allowing users to send and receive faxes
directly from any email client or through a dedicated web interface.
StoneFax is easy to use and can be seamlessly integrated with any e-mail server using standard
SMTP/POP3 protocols without impacting on specific infrastructure requirements.
StoneFax can automatically route incoming faxes in TIFF format to each user's mailbox and
personal web interface, picking out the right recipient by the Called Line Identifier (DID support)
or by the line on which the fax was received. This enables users to check faxes from anywhere in the world using either: • A traditional desktop email client (i.e.: Outlook, Lotus Notes...). This is the Fax through email feature • A web browser (Internet Explorer, Netscape Navigator...). This is the Fax through web feature To send a fax, each user can either: • Create it as a new message in his/her email client, the Email To Fax feature • Upload a document via web through a dedicated web page, the Web To Fax feature • Directly print from any application to the StoneFax network printer, the Print To Fax feature
After the fax is sent, the user receives a transmission report in his/her inbox.
StoneFax automatically manages the outgoing queue, trying to send the fax again if it not succeeded.
StoneFax interacts with the Cisco Systems Voice Gateway as a T.38 endpoint with Fax Relay technology.
In order to activate StoneFax integration with the Cisco Systems Voice Gateway, the administrator
needs to configure some specific dial-peers (please refer to the System Administration Guide) and
a few more (optional) commands. This will be done once and further operations will be automatically managed by StoneFax Web GUI. - No need for additional Hardware or telephone lines: - It does not require dedicated hardware or modems as it leverages the Cisco gateways - It does not require dedicated telephony lines as it shares those plugged into the Cisco VoIP gateways
Hello,I have recovered IP PHONE SPA525G2.I updated the phones 7.6.2.e.I would like to change the language to French.How to do ?I insert the dictionary script:<Dictionary_Server_Script ua='na'>serv=tftp://ip server/chemin;d0=English-US;x0=spa525_en_v...
Hello all. The RV260 router experienced a WAN layer 3 outage (data link is still up) for 3 hours on Nov 18, 2020. During the outage, the Webfilter logs that "Cannot resolve host bcap15.brightcloud.com: Name or service not known." I assume this is the host...
Hello, How can we track the traffic between PC1 and PC3 (send and receive) through CLI, so we get the list of switches where the traffic passed through.Note: The used switches are cisco SF302 and SG300. Thanks in advance.
I have a working CME system with all 7975 phones and CUE that works correctly including MWI. I added an ATA-186 and it too works but the MWI on my AT&T cordless analog phone connected to it. The stutter tone does work when a message is lef...
Hi,I have an RV340w configured to talk to a VDSL modem that is in bridge mode via PPPoE. Both the IPv4 and IPv6 connectivity uses the shared PPPoE credentials and receives an IPv4 address (29 bit subnet) and IPv6 addresses - an ND prefix (64 bits) and a P...