Cisco Discover Protocol (CDP): automatically detects all the devices connected in the network and instructs the devices to use appropriate voice VLAN or QoS parameters.
Cisco Auto Smartports: Based on pre-tested configuration, Smartports auto configures ports with specific levels of Security, QoS, and availability according to the type of connected device.
Cisco Textview: Text-based configuration for those who prefer command line interface (CLI) management. The CLI is full featured (the entire device can be configured solely through the CLI if so desired), and comes with multiple user privilege levels, delivering differing access depending on the user’s authorization level. A menu-based CLI is also present in this release.
Q-in-Q: Allows VLANs to transparently cross a service provider network while isolating traffic among customers.
BPDU Guard: A security mechanism to protect the network from invalid configurations. A port enabled for BPDU Guard is shut down if a BPDU message is received on that port
Secure Core Technology (SCT): Ensures that the switch will receive and process management and protocol traffic no matter how much traffic is received
This release offers several key capabilities in the area of automating voice deployments:
Automatic Voice VLAN creation and propagation to multiple switches in the network
Synchronization of Voice VLAN and QoS parameters with IP Phones and Voice Platforms such as UC3xx/UC5xx
Automatic configuration of switch ports based on the dynamically discovered devices – Access Points, IP phones, Switches, UC platforms, etc
Automatically sets the security levels appropriately for the discovered devices using Auto Smartports
Uses a combination of CDP, LLDP-MED, Auto Smartports, and intelligent software from Cisco to accomplish all of this with no user intervention
Combines with the POE functionality already available across multiple switch models to make voice and video deployments as flexible and cost-effective as possible
Hello, I have an RV340, and I have two internet links from two different ISPs. I would like to configure load balance and failover, but every time I disconnect WAN1 the WAN2 does not automatically take over. I no longer know what to do to make it work.Wha...
hello,i needed to change routers for about 20 custumers.a classical, 2 wans, a routing table, and pptp server...Pre-sales cisco : OK no problem the rv340 is the best for u...i bought a rv340. After testing pptp, does not work or works with a mask of 255.0...
Bom dia, eu tenho um switch SG350 e tenho meu Acess Point da Unifi alimentados via POE. Mas eu tenho alguns acess point Unifi de modelo um pouco mais antigo (Modelo Unifi AP-LR (UAP-LR) e em contato com o manual a alimentação dele é POE 24V, gostaria...