Have you ever configured a unique dial plan or daylight saving time rule on a phone only to come back later and find that your unique configuration has been replaced?
Perhaps you have a SPA phone registered to an Asterisk, Trixbox, Broadsoft, or other call control device and found that the phone automatically registered to a SPA9000 that you introduced to the LAN for testing?
This is because the SPA9000 locates and then auto-provisions any device that is configured [by factory default] to accept control from a SPA9000 on the same network.
Disable this automatic process as follows using the device's web-ui:
SIP tab > Linksys Key System Parameters > Linksys Key System: no
Provisioning tab > Configuration Profile > Provision Enable: no
hey every oneI am working on a sg300 switch that the interface VLAN 1 IP is 192.168.1.224 and the default gateway is 192.168.1.100.the management IP of the switch is accessible from the ICT VLAN 15.everything works ok but I have a virtual machine in VLAN ...
Is there a way to check to see how much data usage I use per month over the WAN (WAN1) on the RV345? I'm on an unlimited WAN connection with my ISP, so it doesn't matter for data caps, I'm just curious if I am able to locate this information if I ever did...