Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

Discover Small Business Solutions

Helpful Small Business Resources

Review Products and Get a gift card

1300

Views

Helpful

Comments

edited on: ‎02-18-2014 ‎05:22 PM

This Document describes the Single Point Setup Feature supported by WAP121/WAP321/WAP5x1 Access Points.

Latest Contents

Firewall rule to block and allow RV130W admin page

Created by EricB1 on 04-16-2021 10:39 AM

Hello community.I'm trying to add a firewall rule in the RV130W to block access to the router administration page. I'm also trying to add a rule to allow access from a specific machine. But the RV130W won't allow me to add rules in the same LAN subnet. Ca... view more

RV130W UDP port forwarding issue

Created by reflexivo on 04-16-2021 10:08 AM

I set up a single port forward on this router for UDP only and a couple of times it has stopped accepting connections. It seems like somehow it has got "jammed", because if I change the public port number on the rule, it starts working again on the new po... view more

IGMP snooping issue with multiple SG250

Created by EmilPopov86633 on 04-16-2021 10:07 AM

Hi,I have the following arrangement:PC1 <-->Port2 SG250(IP.245) Port6<-->Port4 SG250(IP.246) Port2<--> PC2The switches are pretty much set to default except I have upgraded their firmware to latest, set static IPs and enabled IGMP s... view more

RV345 becomes unresponsive 8-9 minutes after reboot

Created by JorgeCampello51922 on 04-16-2021 09:42 AM

My RV345 suddenly got unresponsive. Not sure why. Now when I reboot the router it works and everything seems fine for the first 7-9 minutes of uptime. Then it becomes unresponsive I am using firmware 1.0.03.21I've done resets... view more

How do I migrate existing/configured Cisco small business de...

Created by WesMC on 04-16-2021 08:37 AM

I created my network in the following order:Set up an RV340 router, using its GUISet up an SG350 switch, using its GUISet up a few 140ACs, using the main AP's GUIInstalled a Cisco Business Dashboard (CBD)The CBD discovered the existing equipment:Requested... view more