Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
Cisco SPA series phones and ATAs can use certificate-authenticated HTTPS (SSL) sessions to ensure secure provisioning. For a provisioning server to be acceptable to the SPA phone or ATA, the server must present a certificate signed by Cisco's Certificate Authority (CA).
Over the years, we have added certificate authorities (CA) as needed and for administrative reasons.
If your SPA1xx or SPA232D ATA or SPA5xx IP Phone is running current or newer firmware, 1.3.3 or 7.5.6 respectively, use the newer "Cisco 2k Small Business CA" even though you could use any of the older CAs.
A HTTPS server used for device provisioning must use a certificate signed by the appropriate CA for the device.
Informations in such documents seems to be either obsolete or invalid from scratch. Most devices accept more than one CA, so multiple HTTPS server as suggested by document may be overkill in some cases. But I will leave original ocument above, because I can't test all types and firmware versions.
See table bellow for real cross-compatibility list. It is based on real test of mentioned devices.
Note: according Verisign (now Symantec) tech support, VeriSign Class 3 Secure Server CA based certificates are no longer issued. Class 3 Public Primary Certification Authority rooted certificates are sold under product name "Secure Site" and "Secure Site Pro".
*) Linksys CA certificate embedded on SPA50x has expired on end of Jun 2015. Firmwares older than 7.6.2 has been known not to honor certificate times at all. From 7.6.2 onward certificate times are honored, thus Linksys CA certificate is considered expired e.g. untrusted. SSL connections based on Linksys CA certificate are refused with err 10 (certificate expired).
Hi! I just bought an SG 200-08 switch to split my Internet connection in two vlans where one (apartment) has 100Mb/s and the other vlan (my place) has the rest of the 500Mb/s connection and the apartment devices should not be able to see my devices and vi...
Hi Guys, mi name is Pablo, and i have 2 Cisco RV345, in Firmware Version 1.0.01.20, and the same configuration in 2 routers (changgin only segment ip).I have a link point to point in port 16, for connect 2 branch offices.I crate a route static for vlans a...
I Have 5 spa 525g2 phones and they have a preset ”custom”firmeware fore Telavox, factory reset does not work, it only returns to custom firmware after 5min, i have tried to uppgrade firmeware but stil coes back to ”custom” firme ware, i need to load ...