The SPA303 and SPA50xG IP Phones allow you to control the way you navigate between call and line appearances by adjusting the Line_Navigation parameter in the phone's configuration file, or by adjusting the Phone tab > Miscellaneous Line Key Settings > Line Navigation: Per Call | Per Line parameter using the phone's web user interface (web-UI).
<Line_Navigation ua="na">Per Line</Line_Navigation> <!-- options: Per Call/Per Line -->
Web User Interface:
Phone tab > Miscellaneous Line Key Settings > Line Navigation: Per Call | Per Line
Affect on Calls
Per Line [default]
Scenario: The phone is busy on a call, the default setting of Per Line is in effect, and a second call comes in to the phone:
The phone's display will change to display softkeys for the new, incoming call. This means that you will now see Answer and Ignore softkeys. You have to deal with the new call before you can return to your original call. If you do not like this behavior, consider changing to the Per Call setting.
Scenario: The phone is busy on a call, the Per Call setting is in effect, and a second call comes in to the phone:
The phone's display will change to display softkeys for the new, incoming call. This means that you will now see Answer and Ignore softkeys. You can use the phone's 4-way navigation button to navigate up to the first call and use any of the first call's related softkeys on the first callwhile the new call continues to ring.
You can navigate to the second call and will see Answer and Ignore softkeys for the second call.
Hi, I just bought the above switch to power my network and it works just fine till I want to power any POE device. I tried different devices and non will get power from the switch.The strange thing is, that I can't even open the POE configuration in ...
Greetings, I am having some issue for vloce config for my new SG220-26P-K9 For voice vlan, I had configured ports as access port under data vlan with Voice mode in auto. But the IP phone were not getting ip address from voice vlan instead w...
Hi Support Team, We have recently purchased SPA501G and have to enable LLDP-MED configs and enable Web Interface for config page.I am not able to find out the IVR code for LLDP-MED enabling.And also, I am looking for how to enable Web Interface link(...
Hi everyone,This is my first time configuring WAP581, I need your help!Both ports are connected to the POE switch, but only a 169.254.163.211 address is displayed through the packet capture, and FINDIT has not been able to find any device. The device has ...
Hello,while I am waiting for my first 4 switches I would like to start practicing, simulating my connections, various configurations, vlan, etc, I can do it, I downloaded "Cisco Packet Tracer" but I can't find my switches. There are other tools that refer...