NEW!SPA9000 Voice System Description (Registered partners only - password required) This online training will introduce the student to features and functions of the SPA9000 Voice System, as well as, the various configuration methods available. The four types of configuration methods will be explored with a focus on the Setup Wizard. Upon completing this training, the student will be able to:
Explain each component of the SPA9000 Voice System
Be familiar with the SPA9000 Voice System architecture
Understand SIP CODECs as related to bandwidth
Know where to get additional Resources
NEW!SPA9000 Voice System Installation and Configuration (Registered partners only - password required) This online training introduces the student to the SPA9000 Voice System Installation and Configuration. Upon completing this module, the student will be able to:
Use the Wizard to install, configure & maintain the Voice System
Upgrade device firmware
Backup and restore a device's configuration
Use the Web-User Interface (web-UI) to access devices
Dear all, I just bought a CISCO SG250-26 26 Port Gigabit Smart Switch and I would like to know if it is possible to setup a DHCP Server on the Switch or do I have to by a router to set some static IP to my devices on the Network. Another point i...
Hi..Switch model as far as I remember g300 10 Port.. imagine I have interface like tv connected by Ethernet cable to one of input ports..when switch is turned on all of my user work properly shortly after start the errands the port that belong to special ...
Hi dear..I haveproblem by switch g300 Hi dearperhaps ask why??first of all I have 1 interface that connects to switch. At beginning this process everything is accomplish but after 15min led of port turns off and diconnect happened this switch work ar...
Hi, I can get the MAC address of a SG350 switch with "show system" command but I cannot find a command to get the MAC address of the switch ports like we get with a "show interfaces" on IOS. I noticed that the MAC address used by each port seems...
Hi, The SG350 is a L2/L3 switch.When creating vlan-21 and entered the command "switchport access vlan 21" at every interface every things work fine.The L3 config is as below, and currently it is used to manage the switch only, routing occurs at anoth...