When a router is rebooted with out an IOS image file, it will come up in ROMMON mode. This can be a very frustrating experience for users who are not familar with this process. Using this document, you should be able to put a new image on the UC500.
Connect a PC/Laptop to the WAN port. The port might stay up or go up and down.
Give a PC/Laptop the following settings IP Address: 192.168.1.100 Netmask: 255.255.255.0 Default Gateway: 192.168.1.200
Start a tftp program on PC/Laptop and put an image file in the directory that is being shared. An easy tftp program to use is Pumpkin TFTP. It can be found at http://kin.klever.net/pumpkin/binaries. Do not have CCA running when you start your TFTP program. CCA also uses TFTP and this will interfere with the process.
In my example, the file is uc500-advipservicesk9-mz.124-20.T2. This is case sensitive. You can get image files from http://www.cisco.com/cgi-bin/tablebuild.pl/UC520. They are inside of software packs but start off with uc500-advipservices. You must have a CCO login to access that URL.
The following commands will configure the UC500 and start the TFTP download process. You must connect to the console port of the UC500 for the next steps.
rommon 10 > IP_ADDRESS=192.168.1.200 (This is the temporary IP address assigned to the UC500) rommon 11 > IP_SUBNET_MASK=255.255.255.0 (Same as on the tftp server) rommon 12 > DEFAULT_GATEWAY=192.168.1.100 rommon 13 > TFTP_SERVER=192.168.1.100 (Tftp server's IP address) rommon 14 > TFTP_FILE=uc500-advipservicesk9-mz.124-20.T2 (Exact name - case sensitive) rommon 15 > TFTP_CHECKSUM=0 rommon 16 > tftpdnld rommon 17 > reset This text following text will allow you to cut and paste, making this process easier.
I have a gaming PC that I have set to a static IP address. The Both Wan interfaces are DSL. The gaming PC is being booted off the game in middle of play saying no internet connection. So, I am guessing that packets are being sent on both...
When certain people try to call my home phone it doesn't ring. My home phone is connected to the Cisco SPA 122 and my SIP provider is freephoneline. For instance calls from people with certain phone line providers(BELL Canada) go through, however, others ...
I have two AP's CBW145AC and I need to connect them to each other wired, with the primary supplying data and power wired to the second, which is in another room. After installation and configuration, the second ap does not appear on the network and o...
Hi there, I have been trying to access the web application to manage the Cisco phones (UC320w phones, SPA504G model) in my place of work . I am connected to the network but cannot access it because I'm in the "This content requires the Adobe Flash Pl...