Swap Firmware Images on a Wireless Access Point

Available Languages

Download Options

PDF (272.8 KB)
View with Adobe Reader on a variety of devices
ePub (44.2 KB)
View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
Mobi (Kindle) (62.1 KB)
View on Kindle device or Kindle app on multiple devices

Updated:December 13, 2018

Document ID:SMB4433

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Swap Firmware Images on a Wireless Access Point

Objective

A firmware is the control program for devices like the Wireless Access Point (WAP). WAPs have two firmware images or files. This is so that if one firmware file fails for any reason, the other, a backup or non-active one can be used. You can also choose to use one over the other.

This article explains how to swap the primary or Active and the secondary or non-active firmware image on a WAP.

Applicable Devices

WAP100 Series – WAP131, WAP150
WAP300 Series – WAP351, WAP361, WAP371
WAP500 Series – WAP551, WAP561, WAP571, WAP571E

Software Version

1.0.2.2 – WAP131, WAP351
1.2.1.3 – WAP551, WAP561
1.0.1.7 – WAP150, WAP361
1.0.0.17 – WAP571, WAP571E
1.3.0.3 – WAP371

Swap Firmware Images

Step 1. Log in to the web-based utility and choose Administration > Manage Firmware.

Note: The menu options in the image below may vary depending on the model of the device you are using. WAP361 is used as an example.

The following information is displayed:

PID VID — The product ID (PID) and version ID (VID) of the access point.
Active Firmware Version — The version of the currently active firmware image.
Inactive Firmware Version — The version of the backup firmware image.

Note: This page can also be used for firmware upgrades when an update is available.

Step 2. Click on the Swap Active Image button to load the non-active image and make it active.

Note: In this example, the currently active firmware version 1.0.1.7 will be swapped with the inactive 1.0.1.16.

Step 3. Click OK to switch to the Secondary image. Then the device will reboot.

Step 4. The page changes to show reboot progress. Do not refresh the page or navigate to another page while the reboot is in progress, otherwise, the firmware swap will be aborted. Once the reboot is complete, you will be logged out of the WAP.

Note: Any connection to the WAP may be lost temporarily for a few minutes.