The following list shows all public root CAs currently trusted by the Cisco Jabber Video for TelePresence domain. A valid X.509 certificate signed by one of these public root CAs enables successful certificate verification by the Jabber Video domain. This is required for secure communication with a Jabber Video guest user.
If the public root CA that signed the X.509 certificate of one of your enterprise edge video hosts is not listed, please purchase one of the listed CAs to ensure compatibility.
DigiCert Assured ID Root CA
DigiCert Global Root CA
DigiCert High Assurance EV Root CA
Entrust Root Certification Authority
Entrust.net Certification Authority (2048)
Entrust.net Secure Server Certification Authority
Equifax Secure eBusiness CA-1
Equifax Secure Global eBusiness CA-1
GeoTrust Global CA
GeoTrust Global CA 2
GeoTrust Primary Certification Authority
GeoTrust Primary Certification Authority - G2
GeoTrust Primary Certification Authority - G3
GeoTrust Universal CA
GeoTrust Universal CA 2
DST Root CA X3
DST ACES CA X6
Thawte Premium Server CA
Thawte Primary Root CA
Thawte Primary Root CA - G2
Thawte Primary Root CA - G3
Thawte Server CA
VeriSign Class 3 Public Primary Certification Authority - G3
VeriSign Class 3 Public Primary Certification Authority - G4
VeriSign Class 3 Public Primary Certification Authority - G5
VeriSign Class 4 Public Primary Certification Authority - G3
VeriSign Universal Root Certification Authority
The following public root CA signed the X.509 certificates currently used by the Jabber Video domain:
DST Root CA X3
If you enable certificate verification on your B2B video solution, you must set your enterprise-edge video hosts to trust this public root CA to successfully verify the certificate and enable secure communication.
Hi, I've already configured voice vlan on IOS switchs but I want to test configuration on SMB products.On IOS, we have to do this :SW0(config)#interface fastethernet 0/1
SW0(config-if)#switchport mode access
SW0(config-if)#switchport access vlan 10...
I installed Small Business equipment (RV340, SG350, 140ACs) before installing the Cisco Business Dashboard (CBD). When I fired up CBD: It discovered my equipment, requested existing equipment credentials, and required minor SNMP adjustments. My CBD is awa...
I am trying to set up a VLAN. I follow the documentation to the letter and i can get the VLAn 192-168.2.1 up however I cannot then log into the router. How do I set this up so the VLAN I want to create has internet access and I can still log i...
Hi there,Hi all, I have an RV345 connected to a GPON Fiber Modem.They are in PPOE mode. The internet works just fine. The modem’s config page can be accessed by going to the LAN IP address if the modem is directly connected to the PC via Etherne...