Unified Communications 320W model supports configuration of SIP trunks for Internet Telephone Service Provider VoIP telephony services. Configuration of SIP trunks are done via the Configuration Utility by any partner deploying Cisco UC320.
Cisco maintains a list on the support community of all known validated SIP trunk ITSPs on UC320. How can additional Service Providers be added to the list? Easy, Service Provider or an accredited partner must follow the process described here (Registered partners only). Process is summarized in following steps:
Service Provider express interest on certifying UC320 SIP trunk and be listed. For this we recommend Service Providers to contact your Cisco Account Manager, or send an email to firstname.lastname@example.org.
Service Provider sends Cisco the SIP trunk header info file.
(Optional) If required, Cisco provides the SP with the PMF file.
Service Provider performs Self-testing according to the provided UC320 sample ATP (note we assume you have already a UC320 unit, if not the case, your Cisco Account Manager may be able to source you one).
After tests are completed, SP sends the ATP results, the test sniffer traces (use TCPDump.pmf in Getting Started Documents), and the SIP trunk template info file.
With this information, Cisco completes the SIP trunk configuration document and post it on the support community.
Hi dear..I haveproblem by switch g300 Hi dearperhaps ask why??first of all I have 1 interface that connects to switch. At beginning this process everything is accomplish but after 15min led of port turns off and diconnect happened this switch work ar...
Hi, I can get the MAC address of a SG350 switch with "show system" command but I cannot find a command to get the MAC address of the switch ports like we get with a "show interfaces" on IOS. I noticed that the MAC address used by each port seems...
Hi, The SG350 is a L2/L3 switch.When creating vlan-21 and entered the command "switchport access vlan 21" at every interface every things work fine.The L3 config is as below, and currently it is used to manage the switch only, routing occurs at anoth...
Hi.I've got a question concerning this situation:Switch A (Cisco SG-300) answers on 192.168.1.70/24Switch B (Cisco SG-350X) answers on 192.168.1.90/24.This works as long as I am in the same subnet. But when I try it via VPN I cannot reach switch A an...
So like many other people, we have an SP200-50P PoE Switch that has the same PoE issues as most other people - the switch "works" but it takes 40-45 minutes to boot and the PoE doesn't work. If going to a page for PoE stats or the settings, the devi...