Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
Note: Partners are strongly recommended to upgrade any new or existing deployment to this firmware release
We are pleased to announce the availability of UC320 firmware release 2.1.1. This firmware provides new enhancements in addition to delivering additional quality over its previous release. In addition, this firmware includes support for additional countries, expanding the geographical coverage of UC320W.
Main enhancements included are:
New supported regions: Austria, Chile, France, Germany, Ireland, Italy, Mexico, Portugal, Singapore, Spain and Switzerland (via country pack). New regions' support include language support for French, German, Italian, Portuguese, Spanish for the Phone User Interface, Auto attendant, Voicemail and Configuration Utility.
Phone monitor: Possible now to monitor ALL extensions of a phone on a single line key
New Group Paging option for non-intrusive (gentle) paging.
DID mapping for outbound calls
Day/Night call forward
Clock settings enhancements
Release notes (attached) includes all enhancements and quality improvements.
Before you can upgrade to firmware version 2.1.1, you must install interim version 2.0.12(8). If you do not install the interim release first, the upgrade to 2.1.1 will fail. This process is streamlined by installing the firmware from the cloud.
Hello,I am hoping someone can help point me in the right direction here, I am looking for quite a basic setup. We have just purchased 6 x SG-350 and I am having trouble working out if my config is right. I am used to Catalyst IOS and these switches h...
dear all,I did a factory-reset all on my cisco catalyst 9200 switch.loaded the ios from TFTP. ( went successful )but now I want to store the ios in the flash, because when I restart the switch is goes back in the rommon mode instead of loading the ios.I h...
Hello, I need some hellp with firmware upgradeing.I have set the TFTP server, the AP in configured to fit the enviroment.When I "log" in to CLI I get "<Cisco Controller>" And the usual "enable" function does not work. Please hellp me ...
dear all,I have done a factory reset on my cisco catalyst 9200L-24P with the command: factory-reset allNow I want to load a ios from a usb stick, but it is not loading. the switch is not reading the usb stick and is stuck at the rommon mode.Copying t...
After upgrading my SG200-26 switch to 1.4.11.02, I can no longer access it from Chrome (version 77.0.3865.120). I have cleared the cache, history, etc from my browser. I have rebooted both the switch and the computer I am trying to access it fro...