Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
WebEx Telepresence: Firewall requirements for SIP ALG
This document provides information about the Session Initiation Protocol (SIP) Application Level Gateway (ALG) and why it must be disabled to ensure the proper operation of Cisco WebEx Telepresence.
Hello everyone.I am using an ATA model SPA2012.I am having an issue with audio output gain.In user end, the audio output is too low..I need to increase the audio output volume/gain. Thanks in Advance.
I've got a SG500-28 that I'm trying to create a dynamic LACP bundle but still have it be able to PXE boot on a primary interface without manual intervention. I've discovered that the following configuration works, as long as I physically disconnect the se...
view more
I recently updated the firmware on my SG300-10MP POE switch to version 1.4.10.06 (file name sx300_fw-14106.ros), it is installed in the active and backup file locations. The switch seemed to be functioning perfectly with this firmware, no issues. It ...
view more
Dear Friends!I have cisco SPA502G at office. Suddenly it lost network.I reset it comparing to the settings of other phone but there is no tone and it give error in Ext 1: Faild (403).Is subscriber info has something to do with this? Please guide me i...
view more
We have some SG300-52 Managed Switches, most are SRW2024-K9 V02, but we also have one that is SRW2024-K9 V05. If I understand the release notes for firmware version 1.4.10.06, it is only for hardware V01 and V02. Am I correct in this, or can I apply this ...
view more
