Cisco Community
English
Register
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Get the latest Cisco news in this December issue of the Cisco Small Business Monthly Newsletter

WebEx Telepresence portal: Create your portal password

397
Views
0
Helpful
0
Comments
josadusk
josadusk
‎08-20-2012 09:27 PM
edited on: ‎08-20-2012 ‎09:27 PM

You will use the password you create here to log in to your account on the Cisco WebEx Telepresence portal.

  1. Enter a password. Be sure to follow the password rules displayed onscreen.
  2. Enter the password again to confirm it.
  3. Click Submit.

If you place any WebEx Telepresence service orders in the future, you do not create another WebEx Telepresence portal password. Instead, you log in to the portal using your existing password and skip directly to assigning subscriptions (see WebEx Telepresence portal: Assign subscriptions to users, rooms, or bridges).
0 Helpful
Latest Contents
Reset of WAP121 wireless-N access point
Created by ChristinaRahbek14396 on 01-27-2020 12:03 PM
1
0
1
0
Hello,My english is not very good, but I will try.I have a WAP121 Wireless-N Access Point with PoE and I have reset it by mistake. Therefore I only have a wifi signal in half of our house. As far as I can see, I have to configure it all again, but in orde... view more
SPA122 some Customer Service IVRs not recognizing DTMF since...
Created by ac232 on 01-27-2020 09:31 AM
0
0
0
0
Hello, I have a SPA122 with 1.4.1 SR5. Since applied I have noticed when I call Customer Service for some organizations the IVR does not recognize my selection, however for other organizations it works just fine. Example: if the IVR says select 1 for... view more
How to program softkeys on a SPA514G
Created by matthew.saver on 01-24-2020 03:16 PM
0
0
0
0
I need help programming the softkey functions on my SPA 514G. The user manual has zero instruction on customization. I guess I am the Administrator too :-( The buttons are currently programmed with the default functions: redial, dir, intercom, dnd.&n... view more
Call Attendant stats
Created by Peace2you on 01-24-2020 07:04 AM
0
0
0
0
Good day, I'm running cucm 11.5 and I have a call attendant with 3 operators. Can anyone help me to get a report on how many calls each operator receives per day?
spa525g firmware 7.5.5b
Created by longstone1976 on 01-24-2020 07:00 AM
1
0
1
0
Hello,Where can I get the firmware 7.5.5b for SPA525g? I could not find the versions older than 7.6.0.Thanks.
CreatePlease to create content
Discussion
Blog
Document
Video