Here you can download a tested Provider template for XS4ALL for you UC500.After the use of this template you have to check the next parms in the UC500 box, via CLI.
Go to the access-list area and change / remove ( or add the next lines ) so it seems the lines below !
voice source-group CCA_SIP_SOURCE_GROUP access-list 2 translation-profile incoming SIP_Incoming!voice source-group SIP_Trunk access-list 3
access-list 2 remark CCA_SIP_SOURCE_GROUP_ACLaccess-list 2 remark SDM_ACL Category=1access-list 2 permit 192.168.10.1access-list 2 permit 10.1.10.0 0.0.0.3access-list 2 permit 192.168.10.0 0.0.0.255access-list 2 permit 10.1.1.0 0.0.0.255access-list 3 permit 184.108.40.206
Another thing is, pay attention on the length of the password in the next lines:
no dial-peer outbound status-check potssip-ua credentials username 085877xxxx password 7 [password] realm sip.xs4all.nl authentication username 085877xxxx password 7 [password] no remote-party-id retry invite 2 retry register 3 timers connect 100 registrar dns:sip.xs4all.nl expires 7200 sip-server dns:sip.xs4all.nl connection-reuse host-registrar g729-annexb override
!It may be that the SIP connection will give the error Name and Passord are not correct, change the correct password in the lines:
credentials username 085877xxxx password 7 [password] realm sip.xs4all.nl authentication username 085877xxxx password 7 [password]
With the command:
credentials username 085877xxxx password 0 [new password] realm sip.xs4all.nl
After these changes .. test your SIP connection !
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: