Dear,
Here you can download a tested Provider template for XS4ALL for you UC500.
After the use of this template you have to check the next parms in the UC500 box, via CLI.
Go to the access-list area and change / remove ( or add the next lines ) so it seems the lines below !
!
voice source-group CCA_SIP_SOURCE_GROUP
access-list 2
translation-profile incoming SIP_Incoming
!
voice source-group SIP_Trunk
access-list 3
access-list 2 remark CCA_SIP_SOURCE_GROUP_ACL
access-list 2 remark SDM_ACL Category=1
access-list 2 permit 192.168.10.1
access-list 2 permit 10.1.10.0 0.0.0.3
access-list 2 permit 192.168.10.0 0.0.0.255
access-list 2 permit 10.1.1.0 0.0.0.255
access-list 3 permit 82.101.62.99
!
Another thing is, pay attention on the length of the password in the next lines:
!
no dial-peer outbound status-check pots
sip-ua
credentials username 085877xxxx password 7 [password] realm sip.xs4all.nl
authentication username 085877xxxx password 7 [password]
no remote-party-id
retry invite 2
retry register 3
timers connect 100
registrar dns:sip.xs4all.nl expires 7200
sip-server dns:sip.xs4all.nl
connection-reuse
host-registrar
g729-annexb override
!
It may be that the SIP connection will give the error Name and Passord are not correct, change the correct password in the lines:
credentials username 085877xxxx password 7 [password] realm sip.xs4all.nl
authentication username 085877xxxx password 7 [password]
!
With the command:
credentials username 085877xxxx password 0 [new password] realm sip.xs4all.nl
After these changes .. test your SIP connection !
Regards,
Eric Oosterbaan
Engineer
