cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

402
Views
0
Helpful
0
Replies
zohzoh35
Beginner

WAP 321 unresponsive

I have a brand new WAP 321. the device will not allow me to access. I've tried direct to PC. (Yes IP address config's are correct.), and over the network. Performed a 10 second reset. No change. The power light goes off/on slowly. It comes on for about 15 seconds then blinks off, then back on for another 15 seconds and off again. At approximately the same time the connection light comes on and flickers for about 15 seconds then cuts off for just about a second, at which time the power light also does it's off/on dance. The wifi light doesn't come on at all until I disconnect the ethernet wire from the AP. I've disconnected the power and put it aside for an hours or so. come back later to the same scenario. I did see the power light go red one time, but that was all. Can this device be salvaged or is it just toast?    

0 REPLIES 0