Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
Welcome to the Small Business Support Community!
Have questions with any of the Cisco Small Business? Cisco Experts and employees can help you in this support forum.
Video created by the Cisco eSupport team. Please refer to knowledge base
document #5056, One-to-One Network Address Translation (NAT) on RV130
and RV130W VPN Routers, and #5005, Service Management on the RV130 and
RV130W for more
in My V...
Configuration of LAN and Remote Management Web Access on the RV130 and
RV130W. Video created by the eSupport Content Development team. Please
refer to knowledge base article #5010. Link
in My Videos)This VoD demonstrates the patented Auto Voice Deployment.
You will enjoy the network-wide voice VLAN propagation across our
switches and be done in no time. The competitors, not so automatic. For
partners, time is money. Check it out an...
in My Videos) If you would like to see a higher resolution version,
please click here. Please comment and tell us if this video helped and
what other videos you would like us to produce. Link to article:
I’ve ran into a perplexing situation with (3) ATA 190 where I cannot get the device to register. We are working with a Cisco partner that is hosting our environment with CUCDM. I've attached screen shots of the system info from the ATA, another showing th...
I'm trying to allow my ISR 4331 to be able to send it's syslog to UDP port 42729 to my syslog server. I was able to get it to work if I allowed Self to Internet using match protocol of UDP. I would like to create a match access-group versus a match protoc...
I'm trying to add a dynamic and a static NAT on a ISR4331 device. The dynamic works fine but when I enter in the static I get the error "%Port 22 is being used by system". I cleared the ip nat trans*, remove dynamic NAT and added the static first and stil...
our business just upgraded to the SPA525G2, used with ring central, and I'm trying to configure the intercom. our sales team is used to simply pressing "intercom, *xx" (xx being the extension) and being connected. This doesn't work out of the box with the...
Hi there, I´m from Sweden and am not the best at technical english so bare with me. We have installed an intercom system at an apartment complex which visitors should be able to call the residents cellphone which they intend to visit. The interc...