Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

Discover Small Business Solutions

Helpful Small Business Resources

Review Products and Get a gift card

489

Views

Helpful

Comments

(view in My Videos)

As your business expands, you may wish to migrate to a disk configuration that offers more data protection. For example, you may start out with a Single Disk configuration and migration to RAID1, or you may migrate from RAID5 to RAID6.

This short video explains how to perform RAID level migration.

You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.

Comment

Latest Contents

SPA 525G2 handset not working after failed pairing of blueto...

Created by justrighttechllc on 04-21-2021 08:48 AM

Hi there. I've got a couple 525G2s - and trying to pair different headsets via bluetooth. After trying to pair, and not having my headsets detected, the handset then fails to work - no audio at all. Even after a factory reset.

RV340 VPN client to site options do not work

Created by falter on 04-21-2021 08:22 AM

I have been trying for 3 days to get any of the VPN client to site options on our RV340 to work. I have tried SSL VPN, L2TP, Client to Site... I have followed the directions provided by Cisco but there is no response at all when I try to conne... view more

SG350-20 System Summary unresponsive with firmware release ...

Created by vbec27001 on 04-21-2021 04:55 AM

Hi, SG350-20 "System Summary" unresponsive with firmware release 2.5.7.85 ( just "processing data" ). I have tried after factory reset also , but the result is the same.I had switch back to 2.5.5.47. Any suggestions ?BR, VB

i want to add mac based VLAN in Switch CBS250-24P-4X - switc...

Created by MehdiGhazi12826 on 04-20-2021 03:43 AM

I want to make mac based VLAN by webinterface or ssh sisco commands how can i do thatmy swith model is CBS250-24P-4X - switch422fb2

cant create static NAT in cisco RV340 router

Created by ThuvarageshRajagopal56285 on 04-19-2021 10:59 PM

In the static NAT under firewall I am trying to create NAT rule where when I give the static IP in public IP range tab I am getting error as it is the WAN IP of WAN2. How can I create NAT then. Please help.