Hi, I have Cisco RV345, and looking for a way to isolate 3 devices (LAN Ports) that communicate using Layer 2. VLAN 1 - Standard and running DHCP (ipv4 only) - inter-vlan disabledVLAN 3 - Standard and running DHCP (ipv4 only) - inter-vlan d...
view more
I have a dot1x setup on a sg300: dot1x system-auth-controlencrypted radius-server key xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxradius-server host x.x.x.x usage dot1.xinterface gigabitethernet5dot1x host-mode single-hostdot1x violation-mode shutdown trap 10dot1...
view more
My Setup as follows:Router/FW: 192.168.5.1 || VLAN 6-8 || DHCP server for all VLANsVLAN 6: 192.168.6.1/24VLAN 7: 192.168.7.1/24VLAN 8: 192.168.8.1/24 SG300 Switch: VLAN 1: 192.168.5.5 || L3 ModeConnected to Pfsense on GE25 (Trunk)VLAN Interface confi...
view more
We are using rv130 to connect internet. IPS offering internet connection via PPPOEv6 and IPV6 address. WAN port can receive IPv4 and IPv6 address. How can I config DHCPv6-pd ,so that on of my server on LAN can assign IPV6 address from ISP.&...
view more
Hi, working on a CBS350-8T-E-2G, for reference. some notes: - please could be popups be off by default? (pretty bothering to see al those warnings when you log from a new browser)- Save blinking icon is spawning only when you're going back to ge...
view more