I bought a WVC210 and want to configure it with WPA Enterprise. Regarding to http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6918/ps9692/ps9944/ps9948/data_sheet_c78-504108.pdf it should be an option, but it isn't in the admin config pages. I've tried updating the firmware (1.0.0).
Why doesn't it work? Any help is appricated
That is an excellent question.
here is where I always look, and I dont see it there.....
Am asking inside....
SE US Field Channel
I just spoke to Engineering Project Management. Its very close to being approved and will be posted at that site I referenced.
Please check back periodically, I have no ETA to share.
(The approval pending is an internal Legal review of open source included in the firmware and this usually shouldnt take more than a week or 2)
The firmware is now out and I have the options in the web interface! But, I can't get it to work. We have Cisco Aironet APs with WAP-EAP against a MS IAS (via RADIUS) with certificates configured. I've tried to upload the certificate to the cam but it doesn't work. The webinterface doesn't offer much help. Is there any guide or something like that?