ACL on Vlans without router

[akarsh.malikal]

Hello,

I want to create a link between the vlan's to communicate with Vlan 10 

We have Qty- 2 2960X and Qty-2 2960 all are connected with each other via trunk access.

Configured vlan's on the switch 

vlan10 for server

vlan 100 for voice for UC560

vlan 12 for Wireless ( Air-o-net )

vlan 1 for data

vlan 14 for cam

vlan 15 for lab1

I want all the above mention vlan to communicate with vlan 10 ( Servers ) and vise versa but vlan 100 , 12 , 1 , 14 , 15 should not communicate with each other. Which CLI should i use to do so. Is it possible without a router ( if not  which route will help me to get this done with how many ports )

 

[Mark Malone]

as these are layer 2 switches you could use mac acls to control access in below link  , or get a layer 3 device and apply ipv4 acls to the interface vlans

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_55_se/configuration/guide/scg_2960/swacl.html#wp1289037