Switches - Small Business

Hi, Do you know if REP is supported on 2960X ?  I found that this feature is supported after the release note 15.2(4)E but with the latest release 15.2(5b), i don't have the command "rep". http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst296...

Hi, Does this switch(SF110-24-AU) come with rack ears?

Hi, Just got a new SG200-26 switch and was wondering how can I connect it to my ISP modem? Thanks

Could you please tell me the steps to upgrade my  sg-300-28 switch's  firmwire ......... My current version of Firmwire is 1.3.0.62 Please give me the steps...

Or, please, I need help on how to configure a cisco sf300 with regard to voice vlan, I have studied ccna and I see that the commands are different in this line of switches, I am used to using the cli for its flexibility, as I should proceed. Accordin...

I have configured 3x SG300 switches via CLI (2x SG300-28MP-K9 SW1.3.0.62, and 1x SG300-10PP-K9 SW1.4.0.88), they are configured pretty much identical apart from IP address, and device name.  The 28MP's are fine, however TACACS is not working correclt...

Just bought a Cisco SG-220-26P to replace an existing HP 10/100 PoE switch. The switch will connect to a D-Link DGS-1100-16 smart switch. We have our servers connected to the D-Link and the workstation drops to the Cisco - the single workstation drop...

Hi All, I was wondering which SNMP OID I need to get the stacking status of Cisco 500 Series Stackable Managed Switches via SNMP? I used to use 1.3.6.1.4.1.9.9.500.1.2.1 for Cisco 3750s which was great and I could get member status without any proble...

Dear, I am using the SG300-28 28-Port Gigabit Managed Switch. I divided 10 vlan as follows:  - Vlan1: 192.168.1.1/24  - Vlan 2: 172.168.2.1/24  - Vlan3: 172.168.3.1/24....   - Vlan10: 172.168.10.1/24 2 days a week, the device works normally.By Monday...

I have been unable to configure this switch as a DHCP server.  I have followed the manual, no luck.  What am I missing from the configuration?  I have followed the manual explicitly, but the device will not lease addresses.  Help, please?

Switch model: Cisco SG200-50 (was able to duplicate same issue in SG200-26FP, so I assume the issue exists in all SG200 switches)Firmware: 1.4.7.6, boot ver 1.3.5.06 (on both switches) Yesterday, our Cisco SG200-50 switch took a dump after a desktop ...

Model -     SF300-24P Mode:       Layer 2 Boot Ver:  1.3.5.06 Firm Ver:  1.4.7.6 The SFP ports are both empty - we have never plugged anything into the SFP ports. Port GE4 - one of the Combo ports with SFP and RJ45 connectors - Whenever anything ...

Since introducing vlans and static routes into my network setup with the sg300-10 I've noticed ICMP redirects and higher than expected response times. The redirect messages I see on pings from one vlan to another is what I believe to be the source of...